Just Asking... If i'm correct...

Hi,

I'm using the following suspension block settings..

1XD for Rear Inside
1A for Rear Outside

The Toe-Angle of the Suspension Arms is -2.5 degree...



If i will use the Aluminum Rear Upright (1 degree) included on my kit.... the total toe-in will be...

Rear (1 deg) + Suspension Arms (-2.5 deg) = -3.5 deg of Toe-in


On TB-03D Manual the maximum deg to use in -3.0 deg.. Is -3.5 deg of toe-in setting too much..?

What would you suggest a good deg setting for drifters....??


Thanks...

Jarwin

hi marqzz... what i did to my previous tb03 drifter is remove the toe angle in the rear... better handling for drifting.

I suggest you make your rear 0 toe & camber on the front use the shortest susp block on front so that you will have a short wheel base

Roger that... I'll change my suspension block tonight and make it 0 deg toe...

On front how much toe-out you have guys....??

I've been setting up my evo for years as per manual in every assembly and all is good.. i suggest you do the same.. try to start learning your drifts with just the basic needs for drifting like FOWs and rear spool and when you get the hang of it.. then you play with your setups.. that is if you still need to!

see you on track